The purpose is to give you an idea on how to convert your car to run your car on water. This is to prove to you that this “Run Car on Water” technology is workable in most type of vehicles - TRUCK / RV / MOTORCYCLE / AIRPLANE (ETC)!
STEP BY STEP to Build a Hydrogen Fuel Saver - HHO Generator
Here is the suggested sequence of steps to build a “Super Gas Saver” Kit :
1. Install the CHT (or EGT) gauge and measure your current operating temp range (gasoline), for comparison.
2. Build and test the controller to verify the correct pulse output.
3. Build the reaction chamber and test it with the controller (i.e pressure out).
4. Install the tank, controller, chamber, and pressure fittings.
5. Run engine and adjust the control circuit as necessary for best performance.
6. Install the stainless steel valves and get the pistons/cylinders coated with ceramic.
7. Coat the exhaust system with ceramic without the catalytic converter (or let it rust out and then replace the whole dang thang with stainless steel pipe sections).
YOU WILL NEED
• plastic water tank with pump and level sensor.
• control circuit, wiring, connectors, and epoxy.
• reaction chamber with electrodes and fittings.
• 3/8″ stainless steel flex-tubing, fittings and clamps.
• carb/FI vapor-pressure fitting kit. - pressure, CHT (or EGT), & level gauges.
• stainless steel valves.
• copper mesh junction.
• ceramic surface treatment for cylinders & pistons.
• stainless steel or ceramic treated exhaust assembly.
BASIC TOOLS
• drill, screwdriver and pliers
• hole cutter
• wire-wrap, solder-iron and clippers
• DVM and oscilloscope.
READY TO RUN CAR ON WATER?
SAVE 50% FUEL COST TODAY!
2,137 people from 54 countries have purchase this “Water Powered Car” Guide!
updated : 01 Jun 2008
